Getting Started with TMA-2 Studio Wireless+

Included in the preset:

TMA-2 Studio Wireless+ H10 headband, X01 transmitter, S05 speaker units, E08 earpads, C02 cable, A01 protective pouch.

Step 1: Assemble headphones
please note that this step applies to all TMA-2 presets including custom built.

Attach the speaker units to the headband
Slide the speaker units on to the headband. Match the Right Side speaker unit with the Right Side plug (marked with red). Make sure the text on the speaker units is facing upright.

Attach the earpads to the speaker units
Attach the earpads to the speaker units. And, if you are not wireless, connect the cable to either side.

Step 2: Connecting H10: Bluetooth & Wireless+

Option 1: Wireless+ Link for wireless ultra-low latency

1. Slide the switch on your H10 headband to W+ Link mode (white) and power on
2. Enter pairing mode on H10: Press and hold the top and bottom button until LED flashes quickly

Pairing with X01 Transmitter (Default for H10):

• Power on X01.
• Double press the button to enter pairing mode (LEDs blinking fast).
• Pairing is successful when the LED on H10 and X01 both are solid white.

Pairing with X02 Transmitter (Make sure the firmware on your H10 is updated to be compatible with X02):

• Connect X02 to power-source. 
• The first time X02 is powered on, it will start in pairing mode automatically. To enter pairing mode manually: Hold the button on X02 for 2 sec.
• LED 1 is solid white when the first device pairs. If you have a second device, LED 2 is solid white when it pairs.

Video demonstration for pairing H10-X01:

Option 2: Bluetooth Pairing

1. Slide the switch on your H10 headband to Bluetooth mode (blue) and power on
2. Enter pairing mode on H10: Press and hold the top and bottom button until LED flashes quickly (approx. 3 sec)
3. Activate pairing mode on your connecting device and look for "AIAIAI TMA-2 (H10)".
4. Pairing is successful when the LED on the H10 headband is solid blue.