Firmware-update: H10 Headband & S10 Speaker Units

Modified on Thu, 8 May at 12:55 PM

In this article, you'll find our guides on how to firmware-update the headphone parts, H10 Headband and S10 Bluetooth Speaker Units. Find an overview of the contents below:


Jump to section..



How to firmware-update the H10 Headband

Part of TMA-2 Studio Wireless+ & W+ Link Bundle with H10-X01


Compatible with transmitters: X01 (primary) & X02


Our H10 Headband is compatible with both the X01 and X02 transmitters. While the X01 is the primary transmitter, you can update the H10's firmware to enable compatibility with the X02. You can switch between using your H10 with X01 and X02 by updating the firmware to match your transmitter of choice. 


Click here to find a side-by-side comparison of our transmitters 



Overview over latest firmwares for H10 

H10-X01: 1.2.6 (latest firmware)

  • Shutdown timer in W+ Link mode increased to 2 hours without an audio signal.
  • Improved multi-device playback control in Bluetooth mode.
  • Battery level displayed for 2 seconds after power off. 


H10-X02: 1.8.0 (latest firmware)

  • Solves connection dropout cracking sound issue with X02 transmitter.
  • Shutdown timer in W+ Link mode increased to 2 hours without an audio signal.
  • Improved multi-device playback control in Bluetooth mode.
  • Battery level displayed for 2 seconds after power off. 


H10 Update Instructions for iOS

  1. Download the AIAIAI AUDIO H10 App (click here view in app-store)

  2. Prepare Your H10:
    1. Switch your H10 to Bluetooth mode and connect it to your phone.
    2. Enter pairing mode by pressing the volume up and down buttons simultaneously for 4 seconds.

  3. Open the AIAIAI AUDIO H10 App
    1. Launch the app and follow the on-screen instructions to complete the update.




H10 Update Instructions for Windows

  1. Download the AIAIAI Beta-Updater for Windows (click here to download)

  2. Install the Updater:
    1. Open the downloaded file and complete the installation.
    2. Ensure you select Qualcomm USB Debug Drivers during the Qualcomm Combo Digital Architecture Drivers setup.

  3. Prepare Your H10: Turn on your H10 in Bluetooth mode (switch on the headband must be set to Bluetooth).

  4. Connect Your H10: Use USB-C cable to connect your H10 to your PC.

  5. Update the Device: Select H10 in the Updater and click Update.

  6. Confirm the correct product and complete the update.


Note: Windows Updater only supports firmware version 1.1.2.



Troubleshooting

Troubleshooting for AIAIAI AUDIO H10 App

If you are unable to find your H10 in the app: Close app and forget the H10 on your device. Then put H10 in pairing mode (holding top and bottom button until LED flashes rapidly) and reopen app to search for H10. 


Troubleshooting for Windows Updater

If the updater fails or you are unable to connect your device, try using a different usb-port, or rebooting the computer. 



Please do not hesitate to contact our Support Team if you have any questions or concerns — we are here to help!








Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article