Getting started with TMA-2 Move

Included in the preset

TMA-2 Move Wireless: H03 headband, S10 speaker units, E04 earpads, C05 cable, A01 protective pouch.

TMA-2 Move XE Wireless: H01 headband, S10 speaker units, E10 earpads, C05 cable, A01 protective pouch.

Step 1: assemble headphones
please note that this step applies to all TMA-2 presets including custom

Attach speaker units to the headband
Slide the speaker units on to the headband. Match the Right Side speaker unit with the Right Side plug (marked with red). Make sure that your speaker units are not upside down, the cable lock should always be at the bottom.

Attach the earpads to the speaker units
Attach the earpads to the speaker units. And, if you are not wireless, connect the cable to either side.

3. Pair the S10 with your device

 To turn on the speaker unit press and hold for 3 seconds. Put them into pairing mode by holding the joystick to the right for 5 seconds until the LED starts flashing faster.

Step 2: Connect to your device

Bluetooth Pairing - Connecting the S10 Speaker units via Bluetooth:

Option 1

• When S10 is turned off: Press and hold the joystick button straight down until LED 1) Turns on, 2) Turns White, 3) Starts flashing rapidly

Option 2

• Power on S10’s: Press and hold the joystick button straight down until LED turns on.

• Enter pairing-mode: Hold the joystick to the right until the LED starts blinking rapidly.

When the LED is flashing rapidly, your S10 Speaker units are in pairing mode and ready to connect. Activate pairing mode on your connecting device and look for "AIAIAI TMA-2 (S10)".

Below you will find a video demonstration of the pairing process

Connecting the S10 Speaker units via Cable:

Insert one of our cables on the bottom input on the speaker unit marked L, twist to lock and secure the cable.

Please note that there is no cable lock on the top (between the headband and speaker unit)

You can use any of our cables. Find our selection here